To bait a snap trap, put a small, pea-sized amount of a sticky food, such as peanut butter, on the trigger pedal or in the bait cup, then set the trap. Too much bait lets a mouse eat it without setting off the trap, which is the most common mistake people make.
What bait works on snap traps
- Peanut butter is the bait most often recommended for mice. It is sticky, so the animal has to work at it, which brings it onto the trigger.
- Other sticky foods, such as hazelnut spread, are used for the same reason.
- A fibre on the trigger. Some people tie a small piece of cotton, yarn or dental floss near the trigger. Mice often pull on fibres to gather nesting material, which can set the trap. This is a tip from experienced users, not a guaranteed method.
- Rats need pre-baiting. Rats are more cautious than mice. Many guides recommend putting out bait on its own, without a trap set, for a day or two so the rats become used to it. Then set the trap with the bait.
How much bait to use
Use a pea-sized amount. A mouse can eat a large blob without putting enough weight on the trigger. Replace bait that has dried out, gone stale or been eaten.
Step by step
- Put on gloves before you handle the trap or the bait. Human scent can make rodents cautious.
- Place a pea-sized amount of bait on the trigger pedal, or in the bait cup if the trap has one.
- Set the trap with your fingers clear of the bar. Snap traps can pinch hard.
- Place the trap against a wall, at a right angle to it, with the trigger end toward the wall. Rodents often travel along walls, so this puts the trigger in their path.
- Check the trap daily, remove any catch, and re-bait or reset as needed. How often to check traps covers the general rules.
Where to put snap traps
- Along walls, behind appliances, in cupboards and in corners where you see droppings or gnaw marks.
- Away from food preparation surfaces, if you can.
- Out of reach of children and pets. A trap in an open room is easy for a child or a pet to reach.
Handle traps and catches safely
- Wear gloves when you bait, set and empty traps.
- Do not handle a dead rodent with bare hands. Seal it in a bag and dispose of it as your local rules direct.
- Wash your hands after handling traps, bait or rodents.
- Snap traps can injure fingers when they are set or when a catch is removed, so take your time.
Common problems
- Bait taken, trap not sprung. The bait may be too large, or the animal may be eating it without touching the trigger. Use less bait, and make sure it sits on the trigger.
- Rodents avoid the trap. Rodents can be wary of a new trap or of human scent. Handle traps with gloves, pre-bait for rats, and try a spot along a different wall.
- Trap sprung but nothing caught. The animal may have escaped, or the catch may be elsewhere. Check the trap and the area around it, then reset.
When snap traps are not enough
If you see signs of many rodents, a few traps may not be enough. Sealing entry points and removing food sources usually helps more than traps alone. For a serious or ongoing problem, a licensed pest control professional can assess the situation.
For the general approach to baiting, see bait and lure use in traps.